8/6/2023 0 Comments Nucleo f401re usb hostSelection between single and dual channelled application See Configuration Options for the general configuration options. Target specific configuration option (stm32f103rb) Erasing the flash can be done with STM32 ST-LINK Utility: Target -> Erase chip or with the button Full chip erase. When the application gets stuck on "Restore SOD" the whole flash memory of the microcontroller should be erased, and the download of the software must be started again.Of 16384 bytes" This indicates that the micro-controller board has been connected to the host-computer first before it got powered up by the externalpower-source. "SRAM size: 0x18000 bytes (96 KiB), Flash: 0 bytes (0 KiB) in pages."WARN src/stlink-common.c: unknown chip id! 0xe0042000" This indicates that an unknown (or unpowered) micro-controller board is connected to the host-computer. ![]() When downloading software to the boards, it must to be ensured that only one Nucleo board is connected to the computer during that time.The boards have to be powered up before they are connected via USB to the computer.(e.g: DEMO_NAME=demo-sn-gpio-upm) Use make help to print all available make targets. After the build is finished it is possible to write the executable to the local flash memory. ![]() This can be done with the following command.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |